< Back ×
2008 GMC Yukon Rack and Pinion Seal
My Vehicle Change Vehicle
2008 GMC Yukon
< Back to View All
Steering Racks & Gearboxes
- Department
- Brands
- Prices
Product Specifications- UPC: 770075548522
- Part Description: 2008 GMC Yukon Rack And Pinion Seal Kit
Vehicle Fitment- 2008 GMC Yukon | All Trims | 8 Cyl 4.8L
- 2008 GMC Yukon | All Trims | 8 Cyl 5.3L
- 2008 GMC Yukon | All Trims | 8 Cyl 6.2L
Product Specifications- Other Names: Gear Assembly Upper Seal, Upper Seal
- Item Dimensions: 2.2 x 2.2 x 0.4 inches
- Item Weight: 0.30 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2008 GMC Yukon Ring-Steering Gear Stub Shaft Seal Retainer
Vehicle Fitment- 2008 GMC Yukon | Denali, SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
FAQ for Rack And Pinion Seal Repair
Q: How do you install the Drive Pinion Flange/Yoke and/or Oil Seal?
A:
You can install a new pinion oil seal, apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the splines of the pinion yoke, install the drive pinion yoke, install the washer and a new pinion nut, install the rear propeller shaft, inspect and add axle lubricant to the axle housing and lower the vehicle.
By Bob
GM Specialist
02/11/2022Q: How do you remove the Drive Pinion Flange/Yoke and/or Oil Seal?
A:
You can raise and support the vehicle, remove the rear propeller shaft, place an alignment mark between the pinion and the pinion yoke, install the J 8614-01, remove the washer, remove the pinion nut, and washer, install the J 8614-2 and the J 8614-3 into the J 8614-01, remove the pinion yoke and remove the pinion oil seal.
By Bob
GM Specialist
02/11/2022Q: What are the required tools for the Drive Pinion Housing and/or Seal Replacement?
A:
The required tools are the J 44414 Pinion Seal Installer, J 22912-B Bearing Puller, J 24433 Pinion Cone and Side Bearing Installer, J 37624 Pinion Bearing Installer, J 8092 Driver Handle, J 8608 Rear Pinion Bearing Race Installer and J 8614-01 Flange/Pulley Holding Tool.
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for the pinion gear bearing retainer bolts?
A:
The recommended torque is 88 N.m(65 lb-ft).
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for the propeller shaft yoke retaining clamp bolts?
A:
The recommended torque is 25 N.m(18 lb-ft).
By Bob
GM Specialist
02/11/2022