< Back ×
My Vehicle Change Vehicle
2009 Buick LaCrosse
< Back to View All
A/C & Heating
- Department
- Prices
OEM (Genuine) 2009 Buick LaCrosse AC Relay
PartNumber: 13500114
Product Specifications- Notes: Lacrosse; Instrument Panel, Park Lamp
- Item Dimensions: 3.8 x 2.2 x 0.7 inches
- Item Weight: 0.40 Pounds
- Fitment Type: Direct Replacement
- Replaces: 12193606, 19115080, 15328866, 12135034, 15393412, 12088567, 12135170, 19116057
- Part Description: 2009 Buick LaCrosse AC Relay
Vehicle Fitment- 2009 Buick LaCrosse | Avenir, Base, Convenience, CX, CXL, CXS, Essence, Leather, Preferred, Premium, Sport Touring, Super, Touring | 4 Cyl 2.4 L ELECTRIC/GAS, 4 Cyl 2.4 L GAS, 4 Cyl 2.5 L ELECTRIC/GAS, 6 Cyl 3.0 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS, 6 Cyl 3.8 L GAS, 8 Cyl 5.3 L GAS
$9.31 MSRP:$19.52You Save: $10.21 (53%)
FAQ for Hvac Control Module Repair
Q: What is the blower motor control module installation procedure?
A:
Install the blower control module and install the 2 new screws in the pre-drilled holes on the side of the heat stakes in the blower control module. Tighten the screw to 1.5 Nm. Finally, connect the electrical connector to the blower control module, and install the right-side I/P insulator.
By Bob
GM Specialist
23/12/2021Q: What is the blower motor control module removal procedure?
A:
Start by removing the right-side instrument panel insulator, disconnect the electrical connector from the blower control module and remove 2 heat stakes from the blower control module using a small chisel. Finally, remove the blower control module.
By Omar
GM Specialist
23/12/2021Q: What is the heater and air conditioning control installation procedure?
A:
First, connect the electrical connectors to the HVAC control assembly, and install the HVAC control assembly. Next, install the HVAC control assembly mounting screws and tighten them to 2 Nm. Lastly, install the I/P lower trim panel, and start the engine.
By Omar
GM Specialist
16/12/2021Q: What is the HV AC control module installation procedure?
A:
First, connect the electrical connectors to the HV AC control module, Install the HV AC control module, and the HV AC control module mounting screws. Tighten the mounting screw to 2 Nm. Install the instrument panel lower trim plate, start the engine and run for 1 minute.
By Omar
GM Specialist
16/12/2021Q: What is the HV AC control module removal procedure?
A:
First, remove the instrument panel lower trim plate, remove the HVAC control module mounting screws, and pull the HVAC control module rearward from the instrument panel. Finally, disconnect the electrical connectors from the HVAC control module and remove the HVAC control module.
By Bob
GM Specialist
16/12/2021Q: What is the heater and air conditioning control removal procedure?
A:
First, remove the instrument panel lower trim plate, then remove the HVAC control assembly mounting screws, and pull the HVAC control assembly rearward from the instrument panel. Finally, disconnect the electrical connectors from the HVAC control assembly, and remove them.
By Bob
GM Specialist
16/12/2021See more FAQs (1)