< Back ×
2009 Buick LaCrosse Parking Sensors
My Vehicle Change Vehicle
2009 Buick LaCrosse
< Back to View All
Cameras & Driver Safety
- Department
- Prices
Product Specifications- Notes: Backup Sensor
- Other Names: Back Up Sensor, Sensor
- Item Dimensions: 4.3 x 4.3 x 2.2 inches
- Item Weight: 0.60 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2009 Buick LaCrosse Back Up Sensor
Vehicle Fitment- 2009 Buick LaCrosse | CX, CXL, CXS, Super | 6 Cyl 3.6 L GAS, 6 Cyl 3.8 L GAS, 8 Cyl 5.3 L GAS
FAQ for Parking Sensors Repair
Q: What do you do when you replace the rear object sensor?
A:
When replacing the rear object sensor do not refinish the previous paint, release the sensor, and paint the new rear sensor.
By Omar
GM Specialist
27/12/2021Q: How do you remove the information center telltale assembly?
A:
To remove the information center telltale you have to release the display bezel retainers, tilt the information telltale and disconnect the electrical connector.
By Omar
GM Specialist
21/12/2021Q: What is the installation procedure for the information center telltale assembly?
A:
The procedure is to connect the electrical connector, position the information, and install the bezel into place.
By Omar
GM Specialist
16/12/2021Q: What is the installation procedure for the rear object alarm module?
A:
The procedure is to install the RPA receiver and fastener, and the rear window trim panel.
By Omar
GM Specialist
16/12/2021Q: How do you remove the rear object alarm module?
A:
You can remove the rear object alarm module by removing the following: the rear window trim panel, disconnecting the RPA, and removing the fasteners.
By Omar
GM Specialist
26/12/2020