Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2009 Cadillac SRX Liftgate Release Switch

My Vehicle Change Vehicle
2009 Cadillac SRX
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Trunks & Tailgates
  • Department
  • Brands
  • Prices

1 Product found

4 Q&A for Liftgate Release Switch Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • Dorman OE Solutions Liftgate Release Switch for 2009 Cadillac SRX - 901-071

    Dorman® OE Solutions Liftgate Release Switch for 2009 Cadillac SRX

    PartNumber: 901-071
    $16.58
    Product Specifications
    • OE Part Number: 23423750, 15909695, 15873871, 20789150
    • Package Contents: 1 Liftgate Release Switch
    • UPC: 019495237556
    • Wire Gauge Measurement: 10 ga.
    • Part Description: 2009 Cadillac SRX OE Solutions Liftgate Release Switch
    More Info
    Vehicle Fitment
    • 2009 Cadillac SRX | All Trims | All Engines

FAQ for Liftgate Release Switch Repair

Q: What should you do if replacing the accessory and liftgate control module?
A:
You should reprogram the accessory and liftgate control module.
By Bob
GM Specialist
01/11/2022
Q: What should you remove before replacing the accessory and liftgate control module?
A:
You should remove the body side trim panel.
By Bob
GM Specialist
01/11/2022
Q: What should you remove before replacing the liftgate actuator switch?
A:
You should remove the body side trim panel.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque when you tighten the power liftgate switch screw?
A:
You can tighten the screw to 0.2 Nm (1.7 lb in).
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the proper way to install the liftgate hinge?
A:
You can position the Liftgate Hinges to the location marks on the vehicle, install the bolts that retain the liftgate hinges to the liftgate, install the liftgate to the liftgate, install the nuts retaining the liftgate hinge to the vehicle, close the access doors, install the liftgate assist rods, remove the liftgate support, connect the two electrical connectors, install the grommet to the upper left corner of the vehicle body, connect the electrical connector and the washer hose, install the grommet to the upper right corner of the vehicle body and close the liftgate.
Q: What procedure should you perform if the secondary latch is engaged and the cable end is visible?
A:
You should tighten the cable by turning the hoist shaft clockwise, loosen the cable by turning the hoist shaft counterclockwise 3 or 4 turns, repeat steps 1 and 2 to see if the spare tire can be removed, raise the vehicle, place a transmission jack, or equivalent, under the spare tire, position the center of the transmission jack under the secondary latch release button, raise the jack and lower the tire.