< Back ×
2009 Cadillac XLR Driveshaft
My Vehicle Change Vehicle
2009 Cadillac XLR
< Back to View All
Driveline, Axles & 4WD
- Department
- Prices
Product Specifications- Notes: All; Xlr; All
- Location: Driver Side; Passenger Side
- Other Names: Axle Assembly
- Item Dimensions: 33.0 x 8.5 x 7.1 inches
- Item Weight: 22.10 Pounds
- Fitment Type: Direct Replacement
- Replaces: 10350598, 25941373, 22762284, 15851726
- Part Description: 2009 Cadillac XLR Axle Assembly
Vehicle Fitment- 2009 Cadillac XLR | Base, Platinum, V | 8 Cyl 4.4 L GAS, 8 Cyl 4.6 L GAS
Product Specifications- Notes: Xlr; All
- Other Names: Drive Shaft
- Item Dimensions: 65.1 x 7.7 x 7.7 inches
- Item Weight: 23.30 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2009 Cadillac XLR Propeller Shaft Assembly
Vehicle Fitment- 2009 Cadillac XLR | Base, Platinum, V | 8 Cyl 4.4 L GAS, 8 Cyl 4.6 L GAS
FAQ for Driveshaft Repair
Q: What causes clanking noise in the transmission?
A:
The noise is caused by a flex plate that may be cracked.
By Bob
GM Specialist
29/10/2022Q: How do you replace a broken snap ring?
A:
You remove the driveline tube and inspect the tube.
By Bob
GM Specialist
29/10/2022Q: What causes whirring/squealing noise?
A:
The whirring/squealing noise is caused by a worn bearing.
By Bob
GM Specialist
29/10/2022Q: What is the proper way to install the drive line vibration dampener?
A:
The proper way is to install the 2 dampener bolts, tighten the 50 Nm, and install the exhaust pipe hanger bolts.
By Bob
GM Specialist
29/10/2022Q: What causes scraping and a ticking noise when accelerating?
A:
Adetached balance weight may cause noise.
By Bob
GM Specialist
29/10/2022Q: How do you remove the drive line vibration dampener?
A:
You can remove the exhaust pipe hanger bolts, the 2 dampener bolts, and the dampener.
By Bob
GM Specialist
29/10/2022Q: What causes the propeller shaft to create a rattle-type noise?
A:
Aloose propeller shaft hub clamp bolt can cause a rattling noise.
By Bob
GM Specialist
29/10/2022Q: What are some of the symptoms diagnostic procedures?
A:
Some of the procedures are the diagnostic starting point, scraping noise, and shudder on the accelerator.
By Bob
GM Specialist
29/10/2022Q: What causes the propeller shaft to create a vibration?
A:
The vibration may be caused by a worn rev limiter, a bent propeller shaft, and a broken coupling.
By Bob
GM Specialist
29/10/2022Q: What special tools do you need for the drive/propeller shaft?
A:
You need the slide hammer, the magnetic base dial indicator, and the drivetrain support fixture.
By Bob
GM Specialist
29/10/2022See more FAQs (6)