2009 Chevrolet Equinox Steering Gearbox

First, apply approximately 3/4 of the supplied grease packet into the small end of the boot cavity. Next, install the boot with the large clamp loosely attached and use the J 22610 to crimp the large clamp. After that, install the spring clamp to the small end of the boot, install the jam nut and install the outer tie rod. Finally, install the tire assembly.

First make sure to inspect the steering gear cylinder pipes for cracks, dents, and damage to the threads. Next, lubricate and install the new steering gear cylinder pipe seals onto the steering gear cylinder pipes. After that position, the steering gear cylinder pipe to the steering gear and loosely install the steering gear cylinder pipe fittings. After that tighten the steering gear cylinder pipe fittings to 25 Nm and install the steering gear.

Install the steering gear from the right side of the vehicle and center the gear mounting bushings into the cradle supports. The next hand starts both steering gears to cradle mounting bolts. Connect the intermediate shaft to the steering gear and install the new pinch bolt. After that connect the stabilizer link to the stabilizer bar, connect the tie rod to the knuckle and install a new nut. Tighten the nut to 25 Nm and install the front tires/wheels.