Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2009 Chevrolet Equinox Sunroof Motor

My Vehicle Change Vehicle
2009 Chevrolet Equinox
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Power Sunroof & Convertible Top
  • Department
  • Prices

1 Product found

2 Q&A for Sunroof Motor Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2009 Chevrolet Equinox Motor Asm-Sun Roof Window (W/ Control Module) - 25992774
    OEM 2009 Chevrolet Equinox Motor Asm-Sun Roof Window (W/ Control Module) Diagram - 25992774
    View Related Parts

    OEM (Genuine) 2009 Chevrolet Equinox Motor Asm-Sun Roof Window (W/ Control Module)

    PartNumber: 25992774
    Product Specifications
    • Notes: Equinox, Torrent
    • Other Names: Actuator, Motor
    • Item Dimensions: 5.1 x 5.1 x 11.6 inches
    • Item Weight: 2.20 Pounds
    • Fitment Type: Direct Replacement
    • Part Description: 2009 Chevrolet Equinox Motor Asm-Sun Roof Window (W/ Control Module)
    More Info
    Vehicle Fitment
    • 2009 Chevrolet Equinox | LS, LT, LTZ, Sport | 6 Cyl 3.4 L GAS, 6 Cyl 3.6 L GAS

FAQ for Sunroof Motor Repair

Q: How to replace the sunroof motor/actuator?
A:
You need to pull down to disengage the motor/actuator from the sunroof module, perform the timing/synchronization of the sunroof frame, install the motor, verify the sunroof operation, and ensure the motor/actuator teach process has been done, and verify the proper operation of the sunroof before installing the headliner, then install the headliner.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the sunroof motor/actuator screws?
A:
The recommended torque is 4 Nm (35 Ib in).
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the starter installation procedure?
A:
First position the Starter motor in the engine block, install the starter bolts, and tighten it to 50 Nm. Connect the engine wiring harness electrical connector to the starter, and install the positive battery cable lead and the generator wiring lead to the starter solenoid. Next, install the positive battery cable terminal to the starter solenoid nut and tighten it to 10 Nm. Finally, install the front catalytic converter.
Q: What is the tire pressure indicator sensor installation procedure?
A:
First, clean any dirt or debris from the grommet sealing area. Next, install the sensor nut and tighten it to 7 Nm. After that install the tire on the wheel and the tire/wheel assembly.
Q: How to remove the tail lamp assembly?
A:
You need to pull outward at the forward edge of the tail lamp assembly to disengage the two retainers, then disconnect the electrical connector.