Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2009 Chevrolet Suburban 1500 Automatic Transmission Output Shaft Seal

My Vehicle Change Vehicle
2009 Chevrolet Suburban 1500
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Transmissions Components & Shifters
  • Department
  • Brands
  • Prices

1 Product found

3 Q&A for Automatic Transmission Output Shaft Seal Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • SKF Automatic Transmission Output Shaft Seal for 2009 Chevrolet Suburban 1500 - 15133

    SKF® Automatic Transmission Output Shaft Seal for 2009 Chevrolet Suburban 1500

    PartNumber: 15133
    $5.46
    Product Specifications
    • Bore: 2.374 in
    • Boretite: Yes
    • Outer Diameter: 2.379 in
    • Shaft: 1.5030 in
    • UPC: 085311381383
    • Width: 0.374 in
    • Part Description: 2009 Chevrolet Suburban 1500 Automatic Transmission Output Shaft Seal
    More Info
    Vehicle Fitment
    • 2009 Chevrolet Suburban 1500 | All Trims | All Engines

FAQ for Automatic Transmission Output Shaft Seal Repair

Q: What should be noticed when replacing the Output Shaft Seal?
A:
You should use the J 45000 to remove the seal and use care to avoid damaging the output shaft bushing, lubricate the seal with clean transmission fluid and use the J 36183 to install the seal.
By Bob
GM Specialist
28/10/2022
Q: What are the preliminary procedures for Transmission Output Shaft Seal replacement (Four Wheel Drive)?
A:
You should remove the transfer adapter from the transmission.
By Bob
GM Specialist
28/10/2022
Q: What tools are required to replace the Output Shaft Seal?
A:
You need J 45000 Seal Remover and J 36183 Seal Installer.
By Bob
GM Specialist
28/10/2022

FAQ for Other Repair Info

Q: What should we know about the control solenoid valve and module assembly?
A:
You should inspect the 4 filter plate retaining tabs. A broken tab may not adequately secure the filter plate to the control solenoid valve assembly. And you should align the control solenoid valve assembly with the lower valve body locator pin when assembling. If a replacement Transmission Control Module is installed, you should program the module. Then you should reset the transmission adaptive pressure (TAP) values.
Q: What is the recommended torque when installing the right shock rear mounting bolt on the lower control arm when installing the Fluid Cooler Hose/Pipe?
A:
The recommended torque is 50Nm (37 lb-ft).
Q: What are the preliminary procedures for Case Extension and Gasket Replacement?
A:
You should raise and support the vehicle, remove the propeller shaft, support the transmission with a suitable jack and remove the transmission mount assembly.