2009 Chevrolet Suburban 1500 Exhaust Pipe

You should position and install the Exhaust Manifold heat shield, and bolts to the exhaust manifold, clean the threads of the exhaust manifold bolts, apply a 5 mm (0.2 in) wide band of threadlock GM P/N 12345493 (Canadian P/N 10953488), or equivalent to the threads of the exhaust manifold bolts, install a NEW catalytic converter seal to the exhaust manifold, position the NEW exhaust manifold gasket and exhaust manifold to the cylinder head, ensure that the catalytic converter seal is seated to the catalytic converter, install the exhaust manifold bolts, bend the gasket tab at the rear of the gasket around the cylinder head edge, install the oil level indicator tube to the engine block, install the spark plug wires to the spark plugs, install the spark plug wires to the ignition coils, inspect the spark plug wires for proper installation, fully raise and support the vehicle, install the catalytic converter to exhaust manifold nuts, partially lower the vehicle in order to work through the wheel opening, install the front wheel house liner-right front, install the HO2S and inspect the exhaust system for leaks.

You should install the dash panel Exhaust Heat Shield to the dash panel studs, install the dash panel exhaust heat shield nuts and install the catalytic converter. For 2500 series vehicles, you should position the oil pan skid plate and tighten until snug the 2 rear oil pan skid plate bolts and then install the 2 front oil pan skid plate bolts. For 1500 series vehicles, you should position the oil pan skid plate and install the oil pan skid plate bolts and then position the engine shield to the frame, install and tighten the engine shield bolts and lower the vehicle.

You need J 38185 Hose Clamp Pliers.