FAQ for Hvac Heater Blend Door Actuator Repair
Q: What are the preliminary procedures for Auxiliary Temperature Valve Actuator replacement (Behr)?
A:
You should remove the right rear quarter trim panel, reposition the auxiliary HVAC module inward to gain access to the temp door actuator, and disconnect the electrical connector from the temp actuator.
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the mode actuator?
A:
The mode actuator cam is now accessible.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when installing the Mix Door Actuator Screws?
A:
The recommended torque is 2.5 Nm(16 lb in).
By BobGM Specialist
01/11/2022 Q: What are the preliminary procedures for Mode Valve Actuator replacement?
A:
You should remove the knee bolster, remove the air outlet duct-floor LH and disconnect the electrical connector from the mode actuator.
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the Auxiliary Temp Door Actuator?
A:
You should re-calibrate the air temp actuator.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque when installing the Temp Door Actuator Screws?
A:
The recommended torque is 2.5 Nm(16 lb in).
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the Temp Door Actuator?
A:
You need re-calibrate the air temp actuator.
By BobGM Specialist
01/11/2022 Q: What should be noticed when replacing the Auxiliary Mix Door Actuator?
A:
You should need re-calibrate the mode actuator.
By BobGM Specialist
01/11/2022 Q: What are the preliminary procedures for Auxiliary Temperature Valve Actuator replacement (Delphi)?
A:
You should remove the right rear quarter trim panel and disconnect the electrical connector from the temp door actuator.
By BobGM Specialist
01/11/2022 Q: What are the preliminary procedures for Auxiliary Mode Valve Actuator replacement (Behr)?
A:
You should remove the right rear quarter trim panel, reposition the auxiliary HVAC module inward to gain access to the mix door actuator, and disconnect the electrical connector from the mix door actuator.
By BobGM Specialist
01/11/2022 See more FAQs (10)