2009 Chevrolet Trailblazer Control Arm

First, you need to install the rear axle upper control arm. Then, please install the rear axle upper control arm to the frame mounting bolt and install the rear axle upper control arm to the axle mounting nut and bolt. If it is equipped with air suspension, you should connect the air suspension leveling sensor link to the rear axle upper control arm. Finally, you should remove the rear axle support, install the wheelhouse panel, and install the tire and wheel.

First, you need to remove the tire and wheel, remove the outer tie rod from the steering knuckle, and remove the stabilizer shaft link from the lower control arm. Then, please remove the shock module yoke lower from the lower control arm, remove the lower ball joint from the lower control arm, remove the lower control arm to lower control arm bracket mounting nuts, and remove the lower control arm to lower control arm bracket mounting bolts. Finally, you should pivot the lower control arm outward and downward to disconnect the lower control arm from the lower control arm bracket, and remove the lower control arm from the vehicle.

First, you need to raise and support the vehicle and raise and support the rear axle at the designed D-height. If it is equipped with air suspension, you should depressurize the air suspension system. Then, please remove the rear axle lower control arm to the axle mounting nut and bolt, and remove the rear axle lower control arm to the frame mounting nut and bolt. Finally, you should remove the lower control arm.

First, you need to position the lower control arm ball joint stud to the steering knuckle and pivot the lower control arm outward and upward to connect the lower control arm to the lower control arm bracket. Then, please install the lower control arm to lower control arm bracket mounting bolts, and install the lower control arm to lower control arm bracket mounting nuts. Finally, you should install the shock module yoke to the lower control arm, install the lower ball joint to the steering knuckle, install the stabilizer shaft link, install the outer tie rod to the steering knuckle and install the tire and wheel.

First, you need to remove the tire and wheel, remove and discard the upper ball joint to the upper control arm bolt and nut, and separate the upper control arm from the steering knuckle. Then, please remove the wheel speed sensor wiring harness from the upper control arm. If servicing the left upper control arm, you should remove the battery tray. Finally, you should gently pry out on the inner fender body panel to access the forward-facing bolt, and remove the upper control arm mounting bolts and the upper control arm.