2009 Chevrolet Trailblazer Windshield Washer Hose

First, you need to remove the wiper arms and the air inlet grille panel. Then, please disconnect the washer hose connections from the washer nozzles and disconnect the washer hose from the clips on the air inlet grille panel. Finally, you should remove the washer hose from the air inlet grille panel.

First, you need to disconnect the rear washer hose connection near the coolant tank, remove the washer hose grommet from the hole in the bulkhead, and feed the washer hose into the vehicle. Then, please remove the right front sill plate and the right rear sill plate, roll the carpet inward to expose the wiring harness/hose assembly, remove the rear seat backs and the rear compartment anchors, roll the carpet forward to expose the wiring harness/hose assembly. Finally, you should remove the left rear quarter upper trim panel, open the liftgate to access the pass-through grommet, disconnect the grommet from the liftgate to access the washer hose connection, cut the exposed ends of the washer hose from the body wiring harness, and remove the hose from the vehicle.

First, you need to remove the wiper arms and the air inlet grille panel. Then, please disconnect the washer hose connections from the washer nozzles, and disconnect the washer hose from the clips on the air inlet grille panel. Finally, you should remove the washer hose from the air inlet grille panel.

First, you need to install the washer hose to the vehicle, route the hose along the body wiring harness, tape the washer hose to the body wiring harness, and roll the carpet back into place along the floor panel. Then, please install the rear compartment anchors, the rear seat backs, and the right front sill plate, connect the washer hose connection at the liftgate and connect the pass-through grommet to the liftgate. Finally, you should install the left rear quarter upper trim panel, install the rear washer hose out through the bulkhead, and connect the rear washer hose connection near the coolant tank.

First, you need to install the washer hose to the air inlet grille panel. Then, please connect the washer hose connections to the washer nozzles and connect the washer hose to the clips on the air inlet grille panel. Finally, you should install the air inlet grille panel and the wiper arms.