Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2009 GMC Envoy 4WD Switch

My Vehicle Change Vehicle
2009 GMC Envoy
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Driveline, Axles & 4WD
  • Department
  • Brands
  • Prices

1 Product found

1 Q&A for 4WD Switch Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • Dorman OE Solutions 4Wd Switch for 2009 GMC Envoy - 901-064

    Dorman® OE Solutions 4Wd Switch for 2009 GMC Envoy

    PartNumber: 901-064
    $16.93
    Product Specifications
    • Attached Lead Wires: No
    • Mounting Location: Dash
    • OE Part Number: 15066147, 15066148, 15087623, 15097405, 15132078, 15175465, 15194913, 15807881, 15944371, 25827385, 25965895
    • Package Contents: 1 Switch
    • Terminal Type: 11 Pins
    • UPC: 019495296423
    • Wiring Harness Included: No
    • Part Description: 2009 GMC Envoy OE Solutions 4Wd Switch
    More Info
    Vehicle Fitment
    • 2009 GMC Envoy | All Trims | All Engines

FAQ for 4WD Switch Repair

Q: What is the removal procedure for the Transfer Case Shift Control Switch (GMC, Buick)?
A:
Remove the floor console, and the trim plate, push in on the two tabs securing the control switch to the trim plate, move the control switch toward the front of the trim plate, remove the control switch, and disconnect the electrical connector from the control switch.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: Where may occur front axle lubricant leaks?
A:
Axle shaft oil seals. Differential carrier assembly mating surface. drain plug. fill plug. inner axle tube assembly to differential carrier assembly mating surface. pinion yoke oil seal. and vent tube.
Q: What kind of special tools will be used in the replacement of the Rear Axle Shaft Seal and/or Bearing?
A:
J2619-01-Slide Hammer W 1/2 x 13 Adapter, J 8092-Universal Driver Handle 3/4 x 10 inch, J 21128-Axle Pinion Oil Seal Installer, J 23690-Axle Bearing Installer.
Q: What kind of special tools will be used in the replacement of the Universal Joint-External Snap Ring?
A:
J9522-3 U-Joint Bearing Separator, J 9522-5 U-Joint Bearing Spacer Remover.