< Back ×
My Vehicle Change Vehicle
2009 GMC Savana 2500
< Back to View All
Ignition, Distributors & ECM
- Department
- Brands
- Prices
Dorman® Ignition Lock Cylinder for 2009 GMC Savana 2500
PartNumber: 924-796Product Specifications- Notes: w/Onboard Programming
- Finish: Silver
- Housing Material: Metal
- Installation Hardware Included: No
- Key Programmable: Yes
- Key Quantity: 3
- Lock Material: Metal
- Mounting Hardware Included: No
- UPC: 037495584968
- Winged Bezel: No
- Wiring Harness Included: No
- Part Description: 2009 GMC Savana 2500 Ignition Lock Cylinder
Vehicle Fitment- 2009 GMC Savana 2500 | All Trims | All Engines
$54.45
Dorman® Ignition Lock Cylinder for 2009 GMC Savana 2500
PartNumber: 924-716Product Specifications- Notes: wo/Onboard Programming
- Finish: Black
- Housing Material: Steel
- Key Quantity: 0
- OE Part Number: 15794826
- UPC: 019495353980
- Winged Bezel: No
- Wiring Harness Included: No Harness Required
- Part Description: 2009 GMC Savana 2500 Ignition Lock Cylinder
Vehicle Fitment- 2009 GMC Savana 2500 | All Trims | All Engines
$48.88
OEM (Genuine) 2009 GMC Savana 2500 Cylinder Kit, Ignition Lock
PartNumber: 15794826
Product Specifications- Notes: Express, Savana; W/O Tilt Wheel;W/Tilt Wheel
- Item Dimensions: 3.2 x 2.2 x 1.8 inches
- Item Weight: 0.70 Pounds
- Fitment Type: Direct Replacement
- Replaces: 25756079, 19120038
- Part Description: 2009 GMC Savana 2500 Cylinder Kit, Ignition Lock
Vehicle Fitment- 2009 GMC Savana 2500 | Base, LS, LT | 8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL
FAQ for Ignition Lock Cylinder Repair
Q: What is the removal procedure for the Ignition Lock Cylinder?
A:
The procedure is to disconnect the battery negative cable, disable the SIR system, remove the steering column trim covers, turn the ignition lock cylinder to the start position, insert the tip of an awl into the access hole of the ignition lock cylinder, push down and hold the retaining pin of the ignition lock cylinder, release the ignition lock cylinder to the run position, and remove the ignition lock cylinder.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the TORX(R) screws?
A:
The recommended torque is 7 Nm (62 lb in).
By Bob
GM Specialist
01/11/2022Q: How do you install the Ignition Lock Cylinder Case?
A:
You need to install 3 TORX(R) screws into the lock cylinder housing, install the turn signal cancel cam, the park lock cable into the lock cylinder housing, the ignition switch, and enable the SIR system.
By Bob
GM Specialist
01/11/2022