Other Names: Extension Housing Seal, Output Shaft Seal
Item Dimensions: 3.5 x 3.7 x 1.6 inches
Item Weight: 0.50 Pounds
Fitment Type: Direct Replacement
Replaces: 24207336, 19133150
Part Description: 2009 GMC Sierra 1500 Extension Housing Seal
More Info
Vehicle Fitment
2009 GMC Sierra 1500 | AT4, Base, Denali, Elevation, Hybrid, Pro, SLE, SLT | 4 Cyl 2.7 L GAS, 6 Cyl 3.0 L DIESEL, 6 Cyl 4.3 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 6.2 L GAS
Notes: w/Magna 3023 Transfer Case; 2Spd; Full Time 4WD
Part Description: 2009 GMC Sierra 1500 Front Transfer Case Output Shaft Seal
Vehicle Fitment
2009 GMC Sierra 1500 | All Trims | All Engines
FAQ for Transfer Case Output Shaft Seal Repair
Q: What tool can be used to move the inner seal race forward on the front output shaft?
A:
You can use a small pry bar.
By Bob
GM Specialist
01/11/2022
Q: How do you install the front output shaft seal?
A:
You can install the J 43484 to the J 8092, install a NEW seal onto J 43484, install the seal, install the front propeller shaft and install the transfer case shield.
By Bob
GM Specialist
01/11/2022
Q: How do you install the rear output shaft seal?
A:
You can install a NEW front output shaft seal, install the rear propeller shaft, check the fluid level, install the transfer case shield and lower the vehicle.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the rear output shaft seal?
A:
The procedure is to raise the vehicle, remove the transfer case shield, remove the rear propeller shaft and remove the rear output shaft seal.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How do you replace the transfer case shift control module?
A:
You can disconnect the electrical connector, remove the module from the module bracket and perform the Transfer Case Shift Control Module programming and setup.
Q: What should you remove before replacing the input shaft seal?