Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2010 Buick Enclave Engine Control Module

My Vehicle Change Vehicle
2010 Buick Enclave
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Ignition, Distributors & ECM
  • Department
  • Prices

1 Product found

3 Q&A for Engine Control Module Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2010 Buick Enclave Engine Control Module Assembly (W/O Calibration) - 19300014
    OEM 2010 Buick Enclave Engine Control Module Assembly (W/O Calibration) Diagram - 19300014
    View Related Parts

    OEM (Genuine) 2010 Buick Enclave Engine Control Module Assembly (W/O Calibration)

    PartNumber: 19300014
    $1091.78 MSRP: $1737.11
    You Save: $645.33 (38%)
    Product Specifications
    • Notes: Enclave, Traverse
    • Other Names: ECM, PCM
    • Item Dimensions: 3.1 x 10.6 x 10.2 inches
    • Item Weight: 2.20 Pounds
    • Replaces: 19300015
    • Part Description: 2010 Buick Enclave Engine Control Module Assembly (W/O Calibration)
    More Info
    Vehicle Fitment
    • 2010 Buick Enclave | CX, CXL | 6 Cyl 3.6 L GAS

FAQ for Engine Control Module Repair

Q: What should be done before servicing the Engine Control Module?
A:
Turn the ignition OFF.
By Bob
GM Specialist
01/11/2022
Q: Can I touch the connector pins?
A:
To prevent any possible electrostatic discharge damage to the ECM, do not touch the connector pins.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the bolts?
A:
The recommended torque is 6 N.m (53 lb in).
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the installation procedure for the Ignition Coil?
A:
Install the Ignition Coil. Connect the engine wiring harness electrical connector. Install the fuel injection sight shield.
Q: What is the removal procedure for the Knock Sensor?
A:
Disconnect the negative battery cable. Remove the engine oil filter. Lower the vehicle. Disconnect the engine wiring harness electrical connector. Loosen the Knock Sensor bolt and remove the knock sensor.
Q: How many times should I function the lock?
A:
Function the lock 3 times to distribute the grease inside the sleeve.