Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2010 Buick Enclave Ignition Lock Cylinder

My Vehicle Change Vehicle
2010 Buick Enclave
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Ignition, Distributors & ECM
  • Department
  • Prices

1 Product found

3 Q&A for Ignition Lock Cylinder Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2010 Buick Enclave Ignition Cylinder - 15871577
    OEM 2010 Buick Enclave Ignition Cylinder Diagram - 15871577
    View Related Parts

    OEM (Genuine) 2010 Buick Enclave Ignition Cylinder

    PartNumber: 15871577
    $102.27 MSRP: $169.30
    You Save: $67.03 (40%)
    Product Specifications
    • Notes: W/O Power Adjust; W/Power Adjust
    • Other Names: Ignition Cylinder, Ignition Lock Cylinder
    • Item Dimensions: 3.0 x 1.7 x 1.2 inches
    • Item Weight: 0.30 Pounds
    • Fitment Type: Direct Replacement
    • Part Description: 2010 Buick Enclave Ignition Cylinder
    More Info
    Vehicle Fitment
    • 2010 Buick Enclave | Base, Convenience, CX, CXL, Leather, Premium | 6 Cyl 3.6 L GAS

FAQ for Ignition Lock Cylinder Repair

Q: How many times should I function the lock?
A:
Function the lock 3 times to distribute the grease inside the sleeve.
By Bob
GM Specialist
01/11/2022
Q: What should be done before servicing the Ignition Lock Cylinder?
A:
Remove the steering column upper trim cover. Remove the steering column lower trim cover.
By Bob
GM Specialist
01/11/2022
Q: What should be done before servicing the Ignition Lock Cylinder Opening Trim Cover?
A:
Remove the steering column lower trim cover bolts.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the installation procedure for the Ignition Coil?
A:
Install the Ignition Coil. Connect the engine wiring harness electrical connector. Install the fuel injection sight shield.
Q: What is the removal procedure for the Knock Sensor?
A:
Disconnect the negative battery cable. Remove the engine oil filter. Lower the vehicle. Disconnect the engine wiring harness electrical connector. Loosen the Knock Sensor bolt and remove the knock sensor.
Q: What should be done before servicing the Engine Control Module?
A:
Turn the ignition OFF.