2010 Buick Enclave Power Steering Reservoir

Remove the fuel injector sight shield.

Use clean, new power steering fluid type only. Hoses touching the frame, body, or engine may cause system noise. Verify that the hoses do not touch any other part of the vehicle. Loose connections may not leak but could allow air into the steering system. Verify that all hose connections are tight. Maintain the power steering fluid level throughout the bleed procedure.

Remove the fuel injector sight shield. Remove as much power steering fluid from the remote power steering fluid reservoir as possible. Place drain pans under the vehicle as needed. Compress the power steering reservoir inlet hose clamp and disconnect the hose. Compress the power steering fluid reservoir outlet hose clamp and disconnect the hose. Remove the remote power steering fluid reservoir.

Install the remote power steering fluid reservoir. Connect the power steering fluid reservoir outlet hose and clamp. Connect the power steering reservoir inlet hose and clamp. Clean all excess fluid from the vehicle and remove the drain pans. Fill and bleed the power steering system. Install the fuel injector sight shield.

Install the remote power steering fluid reservoir bracket. Install the remote power steering fluid reservoir bracket bolts. Connect the power steering fluid reservoir outlet hose. Connect the power steering reservoir inlet hose. Clean all excess fluid from the vehicle and remove the drain pans. Install the right-side engine mount strut bracket. Fill and bleed the power steering system. Install the fuel injector sight shield.