2010 Cadillac SRX Floor Pan

First, you should spray GM vehicle care odor eliminator directly or as an additive with carpet shampoo in steam cleaners. You should not use it on any interior surface where plain water would deteriorate and avoid contact with vinegar or any acidic substance. Then, complete eight-page treatment sheets are enclosed within each case of GM Vehicle Care Odor Eliminator. These treatment instructions range from simple vehicle odor elimination to full step-by-step procedures for odor removal from water leaks. If lost, you can contact 800-977-4145 to get a replacement set faxed or e-mailed to your dealership. Instructions and cautions are printed on the bottle, but additional help is available.

You should remove only the side components necessary to remove the carpet from the vehicle when you replace the rear floor panel carpet.

First, you should remove the driver or passenger seat, the center console trim panels, and the center console. After that, you should remove the body hinge pillar trim panel and the center pillar lower trim. Finally, you should remove the floor carpet by pulling the front carpet from under the rear carpet assembly and lifting the carpet out of the vehicle.

For a 1-piece carpet assembly bonded to cotton or fiber padding, you should replace the entire assembly. For a 2-piece carpet assembly with cotton or fiber padding, you should replace the padding only. For a 1-piece carpet assembly bonded to foam padding or attached to synthetic padding and for a 2-piece carpet assembly with synthetic padding, you should use a wet vacuum to remove the excess moisture, blot the face of the carpet with a towel to absorb as much moisture as possible and point a fan at the affected area and air dry the carpet.

First, you should remove the driver or passenger seat and the rear seat. After that, you should remove the center pillar lower trim and the body side trim panel.