2010 Cadillac SRX Harmonic Balancer

First, you should remove the drive belt and install the engine support fixture. Then, you should remove the starter and install the EN-46106 tool. After that, you should lower the engine approximately two inches, and remove and discard the crankshaft balancer bolt. Then, you should install the EN-38416-2-button in the nose of the crankshaft and the EN-41816-remover to remove the crankshaft balancer. Finally, you should tighten the center bolt of the EN-41816 - remover and remove the EN-41816 remover from the crankshaft balancer.

The special tools you need are EN-38416-2-crankshaft button, EN-41816-crankshaft balancer remover, EN-41998-B-crankshaft balancer installer, EN-45059-angle meter, and EN-46106-flywheel holding tool.