2010 Cadillac SRX Turn Signal Bulbs

You should remove the front wheelhouse liner, reach inside the fender well, rotate the bulb socket a quarter turn and remove, pull the turn signal lamp bulb from the lamp socket and ensure the fingers on the turn signal lamp socket point forward upon installation. If the socket fingers point rearward, the bulb socket will not seal in the lamp housing.

You should remove the under electrical center (UEC)cover, disengage the three locking tabs from the cover and remove, rotate the park turn bulb socket counter-clockwise and remove and pull the bulb from the park turn signal bulb socket and replace it.

You should remove the rear tail lamp assembly and rotate the rear turn signal lamp bulb socket counterclockwise from the tail lamp assembly.

The high-intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns, you should never open the high-intensity discharge system ballast or the arc tube assembly starter and you should never probe between the high-intensity discharge system ballast output connector and the arc tube assembly. Then, you should remove the underhood electrical center (UEC)cover, disengage the three locking bs and remove the cover, rotate the bulb socket counter-clockwise, and remove and pull the bulb from the socket and replace it.

The high-intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns, you should never open the high-intensity discharge system ballast or the arc tube assembly starter and you should never probe between the high-intensity discharge system ballast output connector and the arc tube assembly. Then, you should remove the air cleaner assembly, rotate the park turn signal bulb socket counter-clockwise, remove and pull the park turn signal bulb from the bulb socket and replace it.