Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2010 Chevrolet Corvette Air Bag Clockspring

My Vehicle Change Vehicle
2010 Chevrolet Corvette
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Air Bag
  • Department
  • Prices

1 Product found

2 Q&A for Air Bag Clockspring Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2010 Chevrolet Corvette Clock Spring Diagram - 19153097
    View Related Parts

    OEM (Genuine) 2010 Chevrolet Corvette Clock Spring

    PartNumber: 19153097
    $210.74 MSRP: $317.87
    You Save: $107.13 (34%)
    Product Specifications
    • Notes: W/Accessory Cntrl
    • Other Names: Clock Spring
    • Item Dimensions: 7.4 x 5.2 x 5.0 inches
    • Item Weight: 0.90 Pounds
    • Fitment Type: Direct Replacement
    • Part Description: 2010 Chevrolet Corvette Clock Spring
    More Info
    Vehicle Fitment
    • 2010 Chevrolet Corvette | 427, 427 Limited Edition Z06, Base, Grand Sport, Z06, Z06 Carbon, ZR1 | 8 Cyl 6.0 L GAS, 8 Cyl 6.2 L GAS, 8 Cyl 7.0 L GAS

FAQ for Air Bag Clockspring Repair

Q: What is the steering wheel inflatable restraint module coil installation procedure?
A:
Center the SIR coil assembly and install the new SIR coil assembly to the steering shaft assembly.
By Omar
GM Specialist
01/04/2022
Q: What is the steering wheel inflatable restraint module coil removal procedure?
A:
First, disable the SIR system, remove the upper/lower shrouds and remove the steering wheel. Next remove the steering wheel column wire harness from the wire harness straps, and the retaining ring, and remove the SIR coil from the steering shaft.
By Bob
GM Specialist
01/04/2022

FAQ for Other Repair Info

Q: What is the inflatable restraint sensing and diagnostic module installation procedure?
A:
First, remove any dirt and install the SDM horizontally to the I/P center support system. Next point the arrow on the SDM toward the front of the vehicle and install the SDM mounting fasteners. Tighten the fasteners to the 10 Nm and install the SDM harness connector to the SDM. Install the CPA to the SDM harness connector and install the accessory trim plate.