O-Ring A Number/Desc: [24401] / Slim Line Sealing Washer
O-Ring A Quantity: 1
O-Ring B Number/Desc: [24402] / Slimline Washer
O-Ring B Quantity: 1
O-Ring C Number/Desc: [24403] / Slimline Washer
O-Ring C Quantity: 1
O-Ring D Number/Desc: [24404] / Slimline Washer
O-Ring D Quantity: 1
Refrigerant Type: R134A
Style: w/o Solenoid
Suction Inlet Fitting Gender: Female
Suction Inlet Fitting Thread Diameter: No. 10
Suction Inlet Style: Sealing Washer
Suction Inlet Type: Sealing Washer
Suction Outlet Fitting Gender: Female
Suction Outlet Fitting Thread Diameter: No. 12
Suction Outlet Style: Sealing Washer
Suction Outlet Type: Sealing Washer
Super Heat: 10.5
Switch Included: Not Included
Tonnage: 0.600
UPC: 096361394667
Part Description: 2010 Chevrolet Traverse A C Expansion Valve
More Info
Vehicle Fitment
2010 Chevrolet Traverse | All Trims | All Engines
$13.50
FAQ for A/C Expansion Valve Repair
Q: How to install the air conditioning evaporator thermal expansion valve?
A:
The proper way is to install the TXV seal strip, new seal washers, the TXV, the TXV bolts, new sealing washers, the condenser tube, the evaporator hose, the TXV nut, and the air cleaner outlet duct.
By Bob
GM Specialist
28/10/2022
Q: How many bolts does the thermal expansion valve attach?
A:
It attaches 2 bolts.
By Bob
GM Specialist
28/10/2022
Q: What is the preliminary procedure for servicing the auxiliary air conditioning evaporator thermal expansion valve?
A:
The procedure is to recover the refrigerant and remove the retaining nut and the auxiliary A/C evaporator tubes from the auxiliary HVAC module.
By Bob
GM Specialist
28/10/2022
Q: How to remove the air conditioning evaporator thermal expansion valve?
A:
You shall remove the air cleaner outlet duct, the evaporator thermal expansion valve (TXV) tube, the seal washers, the TXV bolts, the TXV, and the seal washers.
By Bob
GM Specialist
28/10/2022
Q: What is the recommended torque for thermal expansion valve bolts?
A:
The recommended torque is 5 N.m (44 lb in).
By Bob
GM Specialist
28/10/2022
FAQ for Other Repair Info
Q: What is the preliminary procedure for servicing the auxiliary blower motor?
A:
The procedure is to remove the right rear quarter trim panel and disconnect the Blower Motor electrical connector.
Q: How to service the heater core?
A:
You shall reposition the Heater Core outward from the heater case, mark the location of the center foam seal, press on foam seals to activate adhesive, and push the heater core until the foam seal around the heater core tank is inserted into the HVAC module and the heater core is fully seated.