Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2010 Chevrolet Traverse Steering Wheel Speed Sensor

My Vehicle Change Vehicle
2010 Chevrolet Traverse
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Steering Systems
  • Department
  • Prices

1 Product found

4 Q&A for Steering Wheel Speed Sensor Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2010 Chevrolet Traverse Angle Sensor - 25853012
    OEM 2010 Chevrolet Traverse Angle Sensor Diagram - 25853012
    View Related Parts

    OEM (Genuine) 2010 Chevrolet Traverse Angle Sensor

    PartNumber: 25853012
    Product Specifications
    • Other Names: Angle Sensor, Position Sensor
    • Item Dimensions: 4.1 x 2.7 x 2.6 inches
    • Item Weight: 0.40 Pounds
    • Fitment Type: Direct Replacement
    • Part Description: 2010 Chevrolet Traverse Angle Sensor
    More Info
    Vehicle Fitment
    • 2010 Chevrolet Traverse | LS, LT, LTZ | 6 Cyl 3.6 L GAS

FAQ for Steering Wheel Speed Sensor Repair

Q: What is the recommended torque for the steering wheel bolt?
A:
The recommended torque is 50 N.m (37 lb-ft).
By Bob
GM Specialist
01/11/2022
Q: How to service the steering wheel?
A:
You shall disconnect all electrical connectors as needed, and remove the steering wheel.
By Bob
GM Specialist
01/11/2022
Q: What is the preliminary procedure for servicing the steering wheel?
A:
The procedure is to remove the inflatable restraint steering wheel module.
By Bob
GM Specialist
01/11/2022
Q: What is the steering wheel service procedure?
A:
Remove the inflatable restraint steering wheel module, disconnect all electrical connectors and remove the steering wheel. Tighten the steering wheel bolt to 50 Nm.
By Omar
GM Specialist
04/03/2022

FAQ for Other Repair Info

Q: How to remove the intermediate steering shaft?
A:
You shall turn the steering wheel to the straight forward position and lock it in place, hoist the vehicle and raise it, disengage the intermediate Steering Shaft boot from the steering gear and the intermediate steering shaft upper seal, and remove the left side instrument panel insulator panel and the intermediate steering shaft.
Q: How to service the steering angle sensor?
A:
You shall disconnect any electrical connector as needed, squeeze the plastic retaining tabs on the supplemental inflatable restraint steering wheel module coil to release and disengage the Steering Angle Sensor, and center the steering angle sensor after installation.
Q: How many screws does the steering column housing cover attach?
A:
The Steering Column housing cover attaches 3 screws.