< Back ×
My Vehicle Change Vehicle
2010 Chevrolet Traverse
< Back to View All
Wipers & Washers
- Department
- Prices
OEM (Genuine) 2010 Chevrolet Traverse Level Indicator
PartNumber: 15254826
Product Specifications- Other Names: Level Indicator, Level Sensor
- Item Dimensions: 3.3 x 2.0 x 1.9 inches
- Item Weight: 0.30 Pounds
- Fitment Type: Direct Replacement
- Replaces: 25790709
- Part Description: 2010 Chevrolet Traverse Level Indicator
Vehicle Fitment- 2010 Chevrolet Traverse | LS, LT, LTZ | 6 Cyl 3.6 L GAS
$19.16 MSRP:$36.14You Save: $16.98 (47%)
FAQ for Washer Fluid Level Sensors Repair
Q: What is the preliminary procedure for servicing the windshield washer solvent heater (traverse)?
A:
You shall remove the air cleaner outlet duct.
By Bob
GM Specialist
02/11/2022Q: How many nuts does the windshield washer solvent heater attach?
A:
It attaches 2 nuts.
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for windshield washer solvent heater nuts?
A:
The recommended torque is 10 N.m (89 lb in).
By Bob
GM Specialist
02/11/2022Q: How to service the windshield washer solvent level indicator?
A:
You shall disconnect the electrical connector, pry outward using a suitable clean container to recover the windshield washer solvent and discard the level indicator and grommet.
By Bob
GM Specialist
02/11/2022Q: What is the preliminary procedure for servicing the windshield washer solvent level switch?
A:
The procedure is to remove the wheelhouse liner to access the level Indicator.
By Bob
GM Specialist
02/11/2022Q: How do I remove the Windshield Washer Solvent Level Indicator?
A:
Start with disconnecting the electrical connectors and use two flat-bladed tools under the lip of the level indicator, pry outward using a suitable clean container to recover the washer solvent. Discard the level indicator and grommet.
By Omar
GM Specialist
11/03/2022Q: How do I replace the Windshield Washer Solvent Heater?
A:
Start with disconnecting the heater from the lower plenum panel studs then disconnect the electrical connectors. Prime the heated washer fluid unit after installation. The normal wash function fills the heater with washer solvent after replacing it. Test for proper operation.
By Bob
GM Specialist
11/03/2022Q: How many nuts attach to the Windshield Washer Solvent Heater?
A:
2nuts attach the windshield solvent heater.
By Omar
GM Specialist
09/03/2022Q: What will need to be removed before servicing the Windshield Washer Solvent Heater?
A:
You will need to remove the air cleaner duct.
By Bob
GM Specialist
02/03/2022Q: What will need to be removed before servicing the Windshield Washer Solvent Level Switch?
A:
You will need to remove the wheelhouse liner to access the level indicator.
By Omar
GM Specialist
02/03/2022See more FAQs (5)