< Back ×
2010 GMC Canyon Back Up Light Bulbs
My Vehicle Change Vehicle
2010 GMC Canyon
< Back to View All
Car Bulbs
- Department
- Prices
$5.33 MSRP:$9.63You Save: $4.30 (45%)Product Specifications- Notes: Canyon, Colorado; Front; Clear; W/O Xtreme Pkg
- Location: Driver Side; Passenger Side
- Item Dimensions: 3.3 x 2.1 x 2.1 inches
- Item Weight: 0.30 Pounds
- Fitment Type: Direct Replacement
- Replaces: 1999368, 12450182, 9442486, 09442486, 01999368, 12450053
- Part Description: 2010 GMC Canyon Run Lamp Bulb
Vehicle Fitment- 2010 GMC Canyon | SL, SLE, SLT, WT, Z71 Fleet, Z71 SL, Z71 SLE, Z85 SL, Z85 SLE | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
$3.42 MSRP:$6.18You Save: $2.76 (45%)Product Specifications- Notes: Canyon, Colorado
- Item Dimensions: 3.2 x 2.1 x 2.1 inches
- Item Weight: 0.50 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2010 GMC Canyon Cargo Lamp Bulb
Vehicle Fitment- 2010 GMC Canyon | SL, SLE, SLT, WT, Z71 Fleet, Z71 SL, Z71 SLE, Z85 SL, Z85 SLE | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
$2.86 MSRP:$5.15You Save: $2.29 (45%)Product Specifications- Item Dimensions: 4.2 x 3.1 x 2.3 inches
- Item Weight: 0.70 Pounds
- Fitment Type: Direct Replacement
- Replaced by: 15883346
- Part Description: 2010 GMC Canyon Stoplamp Bulb
FAQ for Back Up Light Bulbs Repair
Q: How to install the Backup Lamp Bulb?
A:
You need to install the bulbs to the backup lamp sockets. Then you need to install the backup lamp rotating clockwise until the locking tab is fully seated. After that, you need to press the tail lamp to the rear body panel until fully seated, and you need to install the tail lamp screws to the tail lamp. Finally, you need to close the tailgate.
By Bob
GM Specialist
28/10/2022Q: How to remove the Backup Lamp Bulb?
A:
You need to open the tailgate and remove the screws from the tail lamp assembly. Then you need to remove the lamp assembly, and you also need to remove the tail lamp and backup lamp sockets, depressing the locking tab and rotating counterclockwise. Finally, you need to remove the bulbs from the backup lamp sockets.
By Bob
GM Specialist
28/10/2022Q: What is the recommended torque for the tail lamp screws?
A:
The recommended torque is 3 Nm (26 lb in).
By Bob
GM Specialist
28/10/2022