2010 GMC Canyon Door Jamb Switch

You need to remove the rear side access door trim panel and remove the bolt retaining the rear side access Door Check link to the body. Then you need to remove the nuts retaining the rear side access door check link to the door. Finally, you need to remove the rear side access door check link from the door.

You need to open the front door and remove the bolt retaining the front door check link to the body, and you need to remove the front door wiring harness grommet from the body and disconnect the door wiring harness connectors. Then you need to remove the bolts retaining the front Door Hinge keeper straps and lift the front door up off the body side hinges and place them on a clean protected surface. After that, you need to clean the mounting surfaces of the body side hinges with a clean rag, mark the front door hinge locations with a grease pencil, or other suitable markers, and remove the bolts retaining the body side hinges to the body. Finally, you need to remove the hinges from the body.

You need to install the upper latch to the rear side access door and install the lower bolts retaining the upper latch to the rear side access door. Then you need to connect the upper latch rod to the latch and close the rear side access door to self-align the upper latch and tighten the lower rear side access door upper latch bolts. After that, you need to open the rear side access door, install the upper rear side access door upper latch bolt, and install the rear side access door trim panel. Finally, you need to close the rear side access door.