2010 GMC Canyon Driveshaft Center Support Bearing

You need to remove the tires and wheels, and you may need to remove the clip retaining the rear brake drum if required. Then you need to remove the rear brake drums, the rear axle housing cover, the lock pin bolt, and the pinion shaft. Finally, you need to remove the C-lock from the rear axle, then you can remove the rear Axle Shaft.

You need to remove the tire and wheel assembly, drain the front Differential assembly, and remove the front propeller shaft. Then you need to remove the front propeller shaft and remove the electrical connector for the electric motor actuator, and you need to remove the vent hose. After that, you need to support the front differential assembly, and remove the mounting bracket from the vehicle. Finally, you need to remove the front differential assembly from the vehicle.

You need to install the Axle Bearing and the axle shaft seal, and the axle shaft. Then you need to install the tire and wheel assembly. Finally, you need to fill the rear axle with axle lubricant.