2010 GMC Canyon Ring And Pinion

You need to remove the tires and wheels, and you may need to remove the clip retaining the rear brake drum if required. Then you need to remove the rear brake drums, the rear axle housing cover, the lock pin bolt, and the pinion shaft. Finally, you need to remove the C-lock from the rear axle, then you can remove the rear Axle Shaft.

You need to lift the front Differential into position, install the mounting bracket to the differential housing, and install the vent hose. Then you need to install the electric motor actuator and install the electrical connector. After that, you need to install the front wheel drive shafts, and you need to install the front propeller shaft and fill the front differential assembly with fluid. Finally, you need to install the front tires and wheels.

You need to install the Axle Bearing and the axle shaft seal, and the axle shaft. Then you need to install the tire and wheel assembly. Finally, you need to fill the rear axle with axle lubricant.