FAQ for Pillar Panels Repair
Q: How to service the Windshield Side Garnish Molding Assembly?
A:
Tabs must be installed prior to retainers and tabs should be fully seated in the I/P trim panel retainer and valance panel.
By BobGM Specialist
02/11/2022 Q: What is the recommended torque for the Seat Belt Assembly Anchor nuts?
A:
The recommended torque is 70 N.m (52 lb-ft).
By BobGM Specialist
02/11/2022 Q: How to service the Rear Window Lower Garnish Molding Assembly?
A:
You should remove the front and rear seat belt guide covers, ensure the webbing is routed through the guide loop, route the webbing through the garnish molding and then drop the garnish molding over the guide loop, and then secure.
By BobGM Specialist
02/11/2022 Q: What should be done before servicing the Center Pillar Lower Garnish Molding?
A:
You should remove the front door sill plate and the rear door sill plate.
By BobGM Specialist
02/11/2022 Q: How many retainers attach to the Body Lock Pillar Garnish Molding?
A:
There are 3 retainers attached to the Body Lock Pillar Garnish Molding.
By BobGM Specialist
02/11/2022 Q: How many retainers attach to the Front Hinge Pillar Trim Panel Assembly?
A:
There are 2 retainers attached to the Front Hinge Pillar Trim Panel Assembly.
By BobGM Specialist
02/11/2022 Q: What should be done before servicing the Center Pillar Upper Garnish Molding?
A:
You should disable the roof rail supplemental inflatable restraint (SIR) system and then remove the center pillar lower garnish molding.
By BobGM Specialist
02/11/2022 Q: What should be done before servicing the Body Rear Panel Insulator?
A:
You should remove the rear seats, the jack stowage cover, the rear window lower trim, the rear side door sill plates, the rear side door sill plates, the rear seat shoulder belt retractor, and the driver and passenger body lock pillar garnish molding.
By BobGM Specialist
02/11/2022 Q: What should be noted when servicing the Center Pillar Lower Garnish Molding Assembly?
A:
You should ensure seat belt webbing does not become trapped during installation and then tab to be fully seated and installed before the retainer.
By BobGM Specialist
02/11/2022 Q: What is the recommended torque for the Center Pillar Upper Garnish Molding screws?
A:
The recommended torque is 2 N.m (18 lb in).
By BobGM Specialist
02/11/2022 See more FAQs (22)