2010 GMC Yukon Shock Absorber

You can install the park brake cable from the actuator lever, the park brake cable from the backing plate by depressing the locking tabs, the park brake cable, position the Parking Brake Cable to the rear axle bracket, install the bolt and nut (2500 series), position the park brake cable to the cable guides on the vehicle frame, install the cable to the mounting bracket until the tabs lock into place, connect the left rear park brake cable to the intermediate park brake cable equalizer, enable the park brake cable automatic adjuster, and adjust the parking brake.

You can install the steering column, the inflatable restraint steering wheel module coil, the turn signal multifunction switch, the ignition lock cylinder case, the tilt spring, the automatic transmission control, the Steering Shaft lock plate retaining ring, the turn signal switch cancel cam position plate, the turn signal switch cancel cam, the steering shaft upper bearing spring, the steering shaft upper bearing inner race seat, the steering shaft upper bearing inner race, the 2 pivot pins, the steering column tilt head, anti-rotation pin J 42640, the tilt lever, the steering shaft upper bearing.

You can install the vacuum sensor with a check valve and hose assembly to the power vacuum Brake Booster, the vacuum sensor to the vacuum hose and secure the clamp, connect the electrical connector to the vacuum sensor.