< Back ×
My Vehicle Change Vehicle
2010 GMC Yukon
< Back to View All
Steering Systems
- Department
- Prices
OEM (Genuine) 2010 GMC Yukon Sensor Asm-Steering Column Tilt Wheel Position
PartNumber: 15886733
Product Specifications- Notes: Tahoe, Yukon, Escalade
- Other Names: Position Sensor
- Item Dimensions: 4.3 x 3.2 x 2.4 inches
- Item Weight: 0.60 Pounds
- Fitment Type: Direct Replacement
- Replaces: 25833069, 15112675
- Part Description: 2010 GMC Yukon Sensor Asm-Steering Column Tilt Wheel Position
Vehicle Fitment- 2010 GMC Yukon | Denali, Denali Hybrid, Hybrid, SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L ELECTRIC/FLEX, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
FAQ for Steering Angle Sensor Repair
Q: How many steering column bracket screws does Steering Wheel Position Sensor have?
A:
It has a total of 3 steering column bracket screws.
By Bob
GM Specialist
01/11/2022Q: What should I notice in the Steering Wheel Position Sensor Centering removal procedure?
A:
With the wheels of the vehicle facing straight ahead, secure the steering wheel utilizing a steering column anti-rotation pin, steering column lock, or a strap to prevent rotation. If you are reusing the existing sensor, you do not have to align the sensor before removal. Centering is not necessary to install the old sensor. If you are reusing the existing sensor, make an alignment mark on the rotor flange cuff before removing the sensor.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the steering column bracket screws?
A:
The recommended torque is 6 Nm (53 lb in).
By Bob
GM Specialist
01/11/2022Q: What is the preliminary procedure for the Steering Wheel Position Sensor removal?
A:
You can remove the steering column.
By Bob
GM Specialist
01/11/2022Q: What should I notice in the Steering Wheel Position Sensor Centering installation procedure?
A:
If you are reusing the existing sensor, align the marks on the flush rotor flange cuff before installation. The alignment mark must stay aligned until the sensor is seated into the adapter and bearing assembly. If you are reusing the existing sensor, align the marks on the flush rotor flange cuff before installation. The alignment mark must stay aligned until the sensor is seated into the adapter and bearing assembly. If you are reusing the existing sensor, align the marks on the raised rotor flange cuff before installation. The alignment mark must stay aligned until the sensor is seated into the adapter and bearing assembly. If you are installing a new sensor, the new sensor will come with a pin. Do not remove the pin until the sensor is seated. If the pin is not installed in the sensor, order a new sensor.
By Bob
GM Specialist
01/11/2022