< Back ×
My Vehicle Change Vehicle
2011 GMC Yukon XL 1500
< Back to View All
Relays, Wiring & Connectors
- Department
- Prices
OEM (Genuine) 2011 GMC Yukon XL 1500 Connector
PartNumber: 12191503
Product Specifications- Notes: Chevrolet 2009-14 W/O Ltz, Gmc W/O Denali, Towing Receptical; Gmc W/Denali, Cadillac, Towing Receptical
- Item Dimensions: 4.2 x 4.3 x 4.3 inches
- Item Weight: 0.70 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2011 GMC Yukon XL 1500 Connector
Vehicle Fitment- 2011 GMC Yukon XL 1500 | Denali, SL, SLE, SLT | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
$53.76 MSRP:$81.10You Save: $27.34 (34%)
FAQ for Trailer Hitch Connector Repair
Q: How do you remove a trailer hitch?
A:
You can remove the trailer hitch by disconnecting the wiring harness and removing the platform bolts as well as the hitch platform.
By Omar
GM Specialist
09/11/2020Q: How do you connect an aftermarket trailer brake controller?
A:
Locate Connector, locate the trailer brake control circuits, pull the trailering wire harness down, and match the vehicle harness label circuit functions to the trailer brake controller functions, break the tape on the red/black and remove the lid from the electrical center, and Place terminal on the larger of 2 studs at the front of the electrical center.
By Bob
GM Specialist
09/11/2020Q: How do you connect circuit for Auxiliary power?
A:
Locate the red/black wire looped and taped to the chassis, break the tape and route the wire to the front of the underhood, place terminal on the smaller of 2 studs and secure it with an M6 fastener.
By Omar
GM Specialist
09/11/2020Q: What is the installation procedure for a trailer hitch?
A:
The procedure is to install the platform hitch bolts to the frame and rear bumper and connect the wiring harness.
By Omar
GM Specialist
06/11/2020Q: What is the procedure to install an aftermarket trailer brake controller?
A:
The procedure to install an aftermarket trailer brake controller is to do the following: place the terminal on the larger of 2 studs at the front, Locate Connector, locate trailer brake control circuits, pull the trailering wire harness down, match the vehicle harness label circuit functions to the trailer brake controller functions, after completing open the hood and locate the red wire that is taped, break the tape on the red/black and remove the lid from the electrical center.
By Omar
GM Specialist
06/11/2020