Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2000 Cadillac Escalade Air Intake Hose

2000 Cadillac Escalade Air Intake Hose

My Vehicle Change Vehicle
2000 Cadillac Escalade
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Air Filters & Intake Systems
  • Department
  • Prices

1 Product found

2 Q&A for Air Intake Hose Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for Air Intake Hose Repair

Q: How do you remove the air cleaner's fresh air duct/hose?
A:
You can disconnect the negative battery cable and the Intake Air Temperature (IAT) sensor. Then remove the Mass Air Flow (MAF) sensor from the air cleaner outlet duct, and the air cleaner from the wheel housing. Next, we continue rotating the air cleaner upwards until the air cleaner inlet duct is separated from the fender. Then remove the air cleaner cover, the air cleaner element, and the air cleaner inlet duct.
By Bob
GM Specialist
01/11/2022
Q: What is the installation procedure for the air cleaner fresh air duct/hose?
A:
You can install the air cleaner inlet duct, the air cleaner element, the air cleaner cover, and the air cleaner to the wheel housing. Next, align the serrated pin with the mounting bracket and install it by pushing it down until the serrated pin is firmly seated in the bracket. Then, we install the MAF sensor to the air cleaner outlet duct and the IAT sensor harness. Finally, we connect the negative battery cable.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the removal procedure for the throttle cable/linkage?
A:
You need to disconnect the accelerator cable from the Throttle Body lever and remove the accelerator cable from the accelerator cable bracket, the accelerator cable from the cable routing bracket, the accelerator cable from the accelerator pedal, and the accelerator cable from the dash panel.
Q: What is the removal procedure for the manifold absolute pressure (MAP) sensor?
A:
You need to disconnect the negative battery cable and the MAP Sensor harness connector, remove the MAP sensor by pulling straight up with a slight rocking motion and the MAP sensor grommet and discard the MAP sensor grommet.
Q: How do you remove the upper intake manifold?
A:
You need to remove the vacuum brake booster hose, if equipped, and disconnect the accelerator control and cruise control cables (if equipped). Remove the accelerator control cable bracket and set it aside, the PCV tube at the Intake Manifold, the engine wiring harness bracket from the manifold, the EVAP canister purge solenoid valve, the studs holding the upper intake manifold to the lower intake manifold, and the lower intake manifold.