Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2001 Chevrolet Metro A/C System Seal Kit

2001 Chevrolet Metro A/C System Seal Kit

My Vehicle Change Vehicle
2001 Chevrolet Metro
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
A/C & Heating
  • Department
  • Brands
  • Prices

5 Products found

2 Q&A for A/C System Seal Kit Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for A/C System Seal Kit Repair

Q: What should we do to prevent swelling and an ineffective seal?
A:
You should not soak the O-rings in refrigerant oil. Before the installation, inspect the O-rings and the fittings to ensure that the O-rings and the fittings are not nicked or deformed. Replace any nicked parts or any deformed parts to prevent refrigerant leakage.
By Bob
GM Specialist
28/10/2022
Q: What should we do when repairing a joint or a fitting in the Air Conditioning (A/C) system?
A:
You should install new approved O-rings. The only exception is the new replacement components that provide the O-rings.
By Bob
GM Specialist
28/10/2022

FAQ for Other Repair Info

Q: How to install the heater core?
A:
You need to install the Heater Core to the heater case and the heater case.
Q: How to install the blower motor resistor?
A:
You need to install the resistor to the blower case and connect the electrical connector of the Blower Motor Resistor electrical connector, and the PCM.
Q: What is the removal procedure for the condenser?
A:
You need to disable the Supplemental Inflatable Restraint (SIR) system, discharge and recover the refrigerant, disconnect the negative battery cable, remove the front bumper, disconnect the hood latch cable, slide the hood latch cable out from the hood latch assembly, disconnect the electrical connector from the SIR forward discriminating sensor, disconnect the condenser fan electrical connector and the 2 horn electrical connections, remove 1 bolt and the horn, connect the Receiver-dryer outlet-to-evaporator inlet pipe fitting, remove 1 nut and the discharge hose, the 6 screws and the radiator center brace, the 2 condenser mounting bolts and the condenser, cap the refrigerant system openings, remove the 2 bolts and the 2 screws from the condenser fan, and the condenser fan from the condenser.