Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2001 Chevrolet Metro Blower Motor Resistor

My Vehicle Change Vehicle
2001 Chevrolet Metro
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
A/C & Heating
  • Department
  • Brands
  • Prices

3 Products found

2 Q&A for Blower Motor Resistor Repair
Sort by:
Recommended
Filter Results
Sort
View by

FAQ for Blower Motor Resistor Repair

Q: How to install the blower motor resistor?
A:
You need to install the resistor to the blower case and connect the electrical connector of the blower motor resistor electrical connector, and the PCM.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the blower motor resistor?
A:
You need to remove the powertrain control module (PCM), disconnect the electrical connector of the blower motor resistor, and remove 1 screw and the blower-motor resistor from the blower case.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the removal procedure for the heater case/cover?
A:
You need to remove the Instrument Panel (IP), drain the engine cooling system, remove the clamps and the heater hoses from the Heater Core at the bulkhead, disconnect the air duct from the heater case, remove the 2 bolts, the 2 nuts and the heater case, remove the heater case retaining clips and the 2 screws, separate the heater case halves, disassemble the doors and the linkages.
Q: What is the removal procedure for the condenser?
A:
You need to disable the Supplemental Inflatable Restraint (SIR) system, discharge and recover the refrigerant, disconnect the negative battery cable, remove the front bumper, disconnect the hood latch cable, slide the hood latch cable out from the hood latch assembly, disconnect the electrical connector from the SIR forward discriminating sensor, disconnect the condenser fan electrical connector and the 2 horn electrical connections, remove 1 bolt and the horn, connect the Receiver-dryer outlet-to-evaporator inlet pipe fitting, remove 1 nut and the discharge hose, the 6 screws and the radiator center brace, the 2 condenser mounting bolts and the condenser, cap the refrigerant system openings, remove the 2 bolts and the 2 screws from the condenser fan, and the condenser fan from the condenser.
Q: What is the recommended torque for the pressure plate nut?
A:
The recommended torque is 15-20 Nm (10.8-15.2 lb-ft).