Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2008 Cadillac SRX Tie Rod End

2008 Cadillac SRX Tie Rod End

My Vehicle Change Vehicle
2008 Cadillac SRX
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Steering Arms, Links & Rods
  • Department
  • Series
  • Brands
  • Prices

8 Products found

2 Q&A for Tie Rod End Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for Tie Rod End Repair

Q: How to remove the Rack and Pinion Outer Tie Rod End?
A:
You should remove the tire and wheel assembly, loosen the steering linkage inner tie rod nut, remove the rack and pinion outer tie rod end nut, disconnect the rack and pinion outer tie rod end from the steering knuckle using puller J 24319-B and remove the rack and pinion outer tie rod end from the steering linkage inner tie rod.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the rack and pinion outer tie rod end nut?
A:
The recommended torque is 55 Nm (41 lb-ft).
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: How to remove the Steering Knuckle?
A:
You should raise and support the vehicle, remove the tire and wheel, the wheel bearing/hub, the outer tie rod to the Steering Knuckle retaining nut, use the J 24319-B to disconnect the tie rod from the steering knuckle, remove the brake hose bracket to steering knuckle retaining bolts and the upper control arm ball stud to steering knuckle retaining nut, separate the upper control arm ball stud from the steering knuckle, remove the lower control arm ball stud to steering knuckle retaining nut, separate the lower control arm ball stud from the steering knuckle and remove the steering knuckle.
Q: How to install the Intermediate Steering Shaft Seal?
A:
You should make sure the intermediate Steering Shaft seal is seated correctly and then install the intermediate steering shaft seal from the inside of the vehicle and the steering column.
Q: How to remove the Vacuum Brake Booster (RHD)?
A:
You should remove the right closeout/insulator panel, the vacuum Brake Booster push rod retaining clip, the vacuum brake booster pushrod, the cross vehicle brace, the master cylinder from the vacuum brake booster, and the air inlet grille panel, disconnect the vacuum brake booster check valve from the vacuum brake booster, attach the J 22805-B to the vacuum brake booster, unlock the vacuum brake booster from the front of the cowl, depress the vacuum brake booster locking tab out of the cowl mounting flange, remove the vacuum brake booster from the cowl mounting flange, support the vacuum brake booster, push the vacuum brake booster foam filter in enough to access the vacuum brake booster retaining clip, lift the longer leg of the retaining clip upward and remove the pushrod from the vacuum brake booster.