2009 Chevrolet Trailblazer Liftgate Lift Support

First, you need to block the wheels to prevent the vehicle from moving, remove the rubber ashtray inserts and rubber mat from the console, and remove the floor shift control knob, the console storage compartment and the Center Console retaining screws. Then, please adjust the parking brake to the full-up, or fully engaged position, slide the console rearward and raise the rear of the console to expose the electrical connectors, disconnect the electrical connectors, as necessary, adjust the parking brake to approximately halfway position, and remove the center console from the vehicle. If replacing the floor console base, you should remove the HVAC control module, the armrest, the HVAC module and duct assembly, the cupholder, and the HVAC upper duct.

7Front Floor Console Cup Holder Fasteners are needed.

First, you need to install the side reveal molding to the windshield pillar. Then, please install the screws to the side reveal molding. Finally, you should install the push-pin retainers to the front Door Sealing auxiliary weatherstrip located at the base of the pillar, and close the door.